Archery - Simple target pins

Info

First time I printed it with small lateral tips, but this damaged the main tip (probably bad slicer settings) - pic. 3, so I removed it, because lateral tips are not necessary.

no support needed (except "target_pin_v2_type_C" and maybe "...type_B")

Recommended filament: PLA works fine for me, but PETG or ABS would be better? - text me if you try it

Tested on: http://en.yate.cz/yate-sandwich-start-90x90x7cm-detail-U5T5000101.aspx

Print Settings

Rafts: No

Supports:  No

Resolution: 0,2 or better

Infill:  50%

Post-Printing

Tip correction

Little bit of sandpaper work will correct tip ;-)

Category: Sport & Outdoors