Battery COVER FOR LG G2 Exact replica and fit with room for personalisation
This object has been checked for printability, but did not pass the test and was deemed not printable. This object is still shareable and people with this link will be able to see and download the object, so please make sure you watch out and progress with care!
×Battery COVER FOR LG G2 Exact replica and fit with room for personalisation
Replacement Back for LG G2
Will fit following models
LG-D803
LG-D805
LG-D800
LS980
LG-D801
Not VS980 and L-01F due to phone differences (these korean and Japanese Variants have antenna's that pop out)
Designed for when you drop your phone and damage the back, or even want to personalise your phone with a new coloured back. Or even if you just accidentally gunked up your speaker grill (reason why I've designed this and im sending it off to get printed at a local printing company)
Designed to exact specifications of the LG G2 phone, measured accurately from both my G2 model, LS980 edition and specification manual
This is perfect for personalising your phone on a new level-have your name engraved into the back to stop anyone stealing and getting away with it
Utilizes ABS being printed at higher temperatures to create a shell (resolution needed 0.15mm or finer layer height).
Print with ABS
Can be printed using SLA Printer as well
Would advise if FDM, to pre-heat bed to just over ABS Heat temp of 115C in order to allow model to lift cleanly from raft without taking off layers from casing
This is a tricky object to 3D print, whilst a modern cheap 3D printer will have the resolution I would only advise if you have heated bed to allow easier raft seperation.
Due to thin walls you must be careful seperating but will fit phone flush like your original carbon fibre patterned back used to.
Status | Rejected |
Time to do | - 200 minutes |
Material Quantity | 20-30grams depending on resolution/raft layer |
Dimensions | 150mmx80mmx10mm |