Energy Can Stack
Energy Can Stack
Published 2018-02-12T12:27:13+00:00
Attractive & convenient stand which accomodates an entire 6 pack of 25cl (250ml) cans.
The stand consists of a 3D printed block to which 4 used cans slot into the back.
The 4 used cans are held in place permanently with glue Hot glue, or 2-part adhesive
I spray painted the print with silver paint then went over the 3d lettering with black permanent marker.
I printed it at 35% infill
I printed at .3mm Layer height but .2mm would no doubt produce a better result
I printed with a single shell but i strongly reccomend at least 2 shells as my print had a couple of gaps
I printed with a feedrate of 50mm/second
I printed at 205c with a bed temp of 60c
Based on 50mm/second feedrate, 35% infill & one shell my print took 3 hours & 17 minutes
I did experience some lifting on one end therefore i suggest using a brim.
Date published | 12/02/2018 |
Technology | FDM |
Complexity | Easy |