200mm Drone Frame Vertical Stretch V3

Vertical 200mm Quad Frame. Using PTEG frame Weighs 73 grams not including Hardware. Uses 5" props and 2000 series Motors. Print 2 Side Frames, do not mirror, Bolt together with 2- 3mm x .5 x 35mm Socket Screw with 3mm and 4- 3mm x .5 x 8mm Screw. Press in 6- 3mm nuts. Please post comments or ideas.

This is an untested design, I will gladly share Fusion360 file. Design could actually be printed in one piece on newer printers, I did in sections so if one arm gets broken it could be replaced. Thanks

Print Settings

Rafts:

No

Supports:

No

.2

Infill:

25%

Notes:

PTEG or ABS 1.75mm bottom and top layer, 2mm walls