Replacement rubber feet for DJI Mavic PRO

Had an unintended sudden deceleration and lost one of the rubber feet in the back of my Mavic Pro. As I attach larger legs there I needed a replacement. However, DJI doesn't make these available at this point in time outside of repair. So I eyeballed the dimensions as good as I could and printed these in Ninjatek Cheetah that I had around. Little bit softer compared to the originals but this filament is very tough.

Empiricus@Dremomys

Print Settings

Printer:

Monoprice Ultimate

Rafts:

No

Yes

Resolution:

0.150 mm

100

Notes:

Ninjatek Cheetah, 80C PEI Bed, 220C, Fan 40%, extrusion 0.9