Para-SPB: Parametric Stackable Small Parts Bin

I wanted a stackable multi height small part bin system that i could quickly and easily customise for my needs. This is a self serve design so I recommend opening up the fusion 3d file and setting your own parameters and generate the bins your want.

Ive attached a selection of samples so you can have a test print. If any common sizes people would like to see pre generated let me know in the comments. Any feedback on improvements or changes let me know.

Features

• Stackable bins
• Lids for super extra small boxes
• Half height and full height variants
• Sliding Insert trays
• Internal Dividers
• Adjustable label width and length
• Optomised wall thinkness and layer height

Fully Parametric

Based around square standard units, ive used 50mm in mine as well as a seperate height. then change the length and width multiplier to generate your boxes in different configs 1x1, 1x2, 2x2, 1x3, etc 

Experimental Features

The following features are experimental and not been tested / finished so use at own risk or feel free to develop further.

• Modular low profile trays. Only completed theends so far and not been printed yet
• Grid Alignment on Underside - Unsuppress the features in screenshot to enable.