Mounting brackets for Hammond 1593 BeagleBone box

I use a BeagleBone Black to run Octoprint with my Prusa Mini and wanted to reduce clutter and the amount of loose wiring. Mounting it on the bottom surface of my desk was a simple solution.

One of the brackets has a cut-out to in order not to block access to the reset and power buttons of the BeagleBone.

The brackets have a few milimetres of extra space vertically to make room for the rubber feet on the box.

Should work fine with other Hammond 1593 series enclosures of the same size, approximately 77x30mm.

Box part number is 1593HAMBONEBK.