MPCNC Primo F 25mm Z Rails Drilling Tool

As a part of MPCNC Z-Axis assembly, you have to drill in holes for nut traps and ultimately tool holder assembly. I did not have a reliable way of holding the tube still while drilling, so I came up with this - you can screw it somewhere to be held still.

Clamp holding pipe is held with M8x40 socket screw
I drilled it down to plywood sheet using 4.8x19mm wood screw - hole should fit any M5 screw. Plastic in these small legs tends to break, so use a washer if your screw head is not flat

• mpcnc-primo-z-axis-assembly-drilling-clamp - main piece to hold and drill through
• mpcnc-primo-z-axis-assembly-drilling-support-clamp - helper piece to hold the other end of pipe

Hope it will be useful for someone else than me ;-)