Open differential for 3Dsets Jeep Rancher

This is open differential for Jeep Rancher from 3dsets. I test it on version Wagon, but should be possible to mount it also on other versions.
I created it this open diferencial, because I'm using my Rancher in house on vinyl floor and the adhesion is so good - and it overloads cardan joints.

The idea was to use maximum of original parts. For two pieces of differential you need only:

6x bearings 10X15X4 6700 2RS (same like is used everywhere in Rancher)
10x screw M3x12
and 3d printed parts

Print settings for case/box 0.2mm-20%, all other parts 0,15mm-100% infill

I printed on Prusa Mini

Assembly manual should be clear from photos.
Don't forget put in grease.

NOTE: Maybe it will be necessary to shorter Drive Shaft - Differential side, because new differential is little bit longer. On my Wagon version I did only for front axle.