Mario Themed Reptile Hide

This is a mario themed reptile hide intended for a terrarium
129
254
1
2716
updated May 3, 2021

Description

PDF

Information 

Included are models for a mario warp pipe with 4 lower exits and a staircase of standard block tiles found on 1-1 and other levels. The warp pipe and the block staircase connect to eachother through the circular openings on each model. 

Scaling

There are two sets of models included, one with thicker walls and one with thin walls. The thin wall model is intended to conserve filament and print at 100% scale for larger critters. These were the models I used for my terrarium and lizard. The thicker wall models can be scaled down safely (~50% lowest recommended) for smaller critters and still retain structural integrity.

Warp Pipe Cap

Included is a model for a cap to be used with the lower warp pipe exits in case there are some left unconnected and your critter prefers some privacy.

Print Settings

Infill

I recommend using 5-10% infill if you want to conserve filament. I used 5%.

Supports

Supports should be used for both the warp pipe and block staircase. I used 5 degree overhang for the block staircases and 10 degree overhang for the warp pipe.

Brim/Raft

I used a 3mm brim to ensure my model would not move off the print bed 20 hours in.
 


 

Tags



Model origin

The author marked this model as their own original creation.

License