Cisco 7970 replacement stand mechanism

This is a replacement "clip" for the inside of a Cisco 7970 (and any model with the same case).

As you can see in the image the original clip disintegrated so I decided to model is in Fusion 360 and print it.

There are two versions. The SIMPLE one is easier to print as it doesn't have all the extras but works perfectly fine.

I strongly recommend you print this in PETG as PLA is probably going to snap quite quickly.

Print instructions

Category: DIY Summary

This is a replacement "clip" for the inside of a Cisco 7970 (and any model with the same case).

As you can see in the image the original clip disintegrated so I decided to model is in Fusion 360 and print it.

There are two versions. The SIMPLE one is easier to print as it doesn't have all the extras but works perfectly fine.

I strongly recommend you print this in PETG as PLA is probably going to snap quite quickly.

Print Settings

Printer: Anycubic Kossel

Rafts: No

Supports: Yes

Resolution: 0.1

Infill: 30

Notes:

In order for the fine parts to work this needs to printed at 0.1 or better. Also make sure your supports come off clean.