Echine FPV Focal Extender

I purchased budget FPV googles (Echine EV800) and the focal distance was very wrong for my very good eyes. I don't wear glasses and have no vision problems. So, I wasn't sure why I had a hard time focusing on the display with these goggles and there is no way to adjust focus on this model. However, when I separated the two sections, I found I could focus very well if the halves were separated by about 2-3 finger widths. So, I designed this spacer to add about 1.5", which allowed me to focus with no eye strain and did not affect my field of view.

Print instructions

Category: R/C Vehicles Summary

I purchased budget FPV googles (Echine EV800) and the focal distance was very wrong for my very good eyes. I don't wear glasses and have no vision problems. So, I wasn't sure why I had a hard time focusing on the display with these goggles and there is no way to adjust focus on this model. However, when I separated the two sections, I found I could focus very well if the halves were separated by about 2-3 finger widths. So, I designed this spacer to add about 1.5", which allowed me to focus with no eye strain and did not affect my field of view.

Print Settings

Printer Brand: Prusa

Printer: Prusa Mk2

Rafts: No

Supports: Yes

Resolution: 0.2mm

Infill: 15%

Notes:

I printed with the tabs on the top surface using supports throughout. I do suggest removing the supports from inside the slot cavity as they are difficult to remove after printing and my printer bridges that gap just fine.