Commodore 64 C64 Ultimate II+ Cart Tape Adapter Housing Case

This is my proposition of housing of the tape adapter of Ultimate II+ cartridge for Commodore 64. In my version many details have been changed and improved. Take a look on the attached pictures.

To mount PCB inside the housing first you need to tilt it and push the side with tape connector into the slot in wall. Then press gently rest of PCB. If you have any problems with assembly try to smooth out sharp edges with a knife.

I propose to print both parts on smooth table to make the line of connection parallel as possible. So you have to use some supports. To mount use 3x15mm wood screws with cone shape heads.

I added v2 of lower part of housing, which has additional (5mm height) support at the rear side. It prevents all connected elements from unwanted bending.

Print instructions

Printer Brand:
Prusa

Printer:
I3 MK3S

Rafts:
No

Supports:
Yes

Resolution:
0.2

Infill:
20%

Filament:
PlastSpaw PLA, ABS, ASA, PETG

Notes:
Use supports and 3 perimeters.