Better Xacto Blade Holder Cover

Being a character with a low roll on dexterity, I found a way I could contribute to Unicorn Hatmaker's fantastic blade holder and make a cover that's a wee bit easier to put on.

This cover is designed to fully enclose the top portion of the pointy bit and handle. It takes into account the fastener with some added clearance. It also has a slight lip that should help retain it. The overall fit is intentionally loose.

There's even a little grippy portion on the top that helps a bit with grip, but also reminds you which end you ought to grasp with your fingers.

With any luck this will help you (and me) reduce the number of times being stabbed if only just a little.

Print instructions

This prints pretty well without supports. I personally used clear PETG because I really like how hard it is to photograph.