P802ma Tronxy A8 clone upgrade parts

Power supply cover upper and lower ( allows for fan breathing and a cheap 1$ light switch for the power switch )

as well vertical hulk braces with hexagon decor designed to hit all the precut screw holes inteh acrylic frame.

this adds rigidity to the frame and nicer prints.

i have used some other mods but i am remixing them to be integral parts. and will add them to this collection of upgrades that are more than just aesthetic

Print instructions

Category: 3D Printer Parts Summary

Power supply cover upper and lower ( allows for fan breathing and a cheap 1$ light switch for the power switch )

as well vertical hulk braces with hexagon decor designed to hit all the precut screw holes inteh acrylic frame.

this adds rigidity to the frame and nicer prints.

i have used some other mods but i am remixing them to be integral parts. and will add them to this collection of upgrades that are more than just aesthetic

Print Settings

Printer Brand:

Anet

Printer:

A8

No

Supports:

Doesn't Matter

.2

Infill:

15%

Notes:

5 top/bottom/side layers (for strength)
260 deg

80 deg bed

lower them 5 degrees after first two layers.

print speed was 100% at 55mm/s
with 101% flow

Gyroid infill (may have upped it to 25% but as long as you are hot and fat on your lines it should be plenty strong enough